How to reset BIOS Password via Jumpers for PowerEdge R740

This video will demonstrate reset procedure for BIOS Password via Jumpers for PowerEdge R740.

Disabling forgotten password

Prerequisites
Power off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
Remove the system cover.
Move the jumper on the system board jumper from pins 2 and 4 to pins 4 and 6.
Install the system cover.
The existing passwords are not disabled (erased) until the system boots with the jumper on pins 4 and 6. However, before you assign a new system and/or setup password, you must move the jumper back to pins 2 and 4.

NOTE:If you assign a new system and/or setup password with the jumper on pins 4 and 6, the system disables the new password(s) the next time it boots.
Reconnect the system to its electrical outlet and power on the system, including any attached peripherals.
Power off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
Remove the system cover.
Move the jumper on the system board jumper from pins 4 and 6 to pins 2 and 4.
Install the system cover.
Reconnect the system to its electrical outlet and power on the system, including any attached peripherals.
Assign a new system and/or setup password.